Dodo Juice Sample Product Testing

Ok so this afternoon I washed my car and used Lilac Quick Detailer – Time To Dry on my rear quarter panel. I only did it in a small area as I wanted to see how the beading would be effected so below is a picture of before.

Panel Test Rear

Ford SportKa Rear Quater Dodo Juice Product Sample

I sprayed Lilac Quick Detailer on to the area and dried with my towel I noticed the water dispersed a lot quicker from the panel into the towel than normal and in general a lot less effort was needed to get the smaller water droplets removed.
This shine on the area did seem mildly improved over how I remember it. Only time will tell how the beading will be affected so i will keep my eye on it.

Red Quick Detailer – Red Mist TEST

On my Boot Lid i tested Red Quick Detailer – Red Mist I decided to split it into three sections the left hand side I have left with Chemical Guys Jetseal 109 on and the right hand side I clayed and then applied 2 coats of Autoglyms Super Resin Polish. When I had buffed the final coat off it was really noticeable which side had been polished even with really cold hands as mine where.

I then sprayed Red Mist on to the area and did a wipe on and wipe off technique until no trace was left i found it was better not to spray loads on the panel as it seemed to be harder work to buff it off. 
I then repeated this twice too both areas both polished and unpolished. When I had finished you couldn’t tell the difference in touch between the polished and none polished area. When it rains it will be interesting to see which area beads the best and how long it lasts.

Panel Test Boot

Ford SportKa Boot Lid Dodo Juice Red Mist Applied

No Comments »

rory on December 3rd 2008 in Product Testing

Trackback URI | Comments RSS

Leave a Reply